top of page

Two 1/2" mounting holes ( With thick ears to take hits without breaking)Hang from both holes for more stability but you can hang from a single hole

We utilize a CNC laser cutting table for the cutting of all our AR500 products.

Plasma cutting cuts slowly, this puts a lot of heat into the steel. ( Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening ita™s edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods.

Superior Material : AR500 3/8" steel with 477 a" 550 BHN

Minimum surface hardness of 477 BHN. Core hardness 450 min BHN

3/8a AR500 steel targets work great for the following calibers 223, 5.56, 5.45 X 39, 7.62 X 39 and 308. For velocities over 3000fps MV use at 200 yards minimum. Handguns should be used no closer than 10 yards and rifles 100 yards.

All targets are raw and unfinished

All of our 3/8" targets carry a limited lifetime guarantee from breakage


Part number: TSG-GGcb4

Gong Diameter: 8, 10 and 12"

Package Contents: Set of one 8, 10 and 12"

AR500 steel Gong Target

Weight: 18 pounds

3 Laser Cut Set AR500 Steel 8,10",12" x 3/8" Shooting Target Gong

    • Facebook Social Icon
    • YouTube Social  Icon
    • Instagram Social Icon
    • Pinterest Social Icon
    • Vimeo Social Icon
    • Twitter Social Icon
    • LinkedIn Social Icon
    • Snapchat Social Icon
    • Tumblr Social Icon
    • Trip Advisor Social Icon
    Copyright 2020© SumoTac, LLC
    bottom of page